Table of Contents
Advertisement
MCO25plus Operating Instructions
6.5.1
Parameters in Superpulse Mode
Adjustment range: Average laser power
The superpulse mode can also be combined with the "cycle" function. Cycle times are set in
the same way as for pulse trains.
6.6
Scanner Operation*
6.6.1
Mounting the Scanner
To use the MCO25plus in scanner mode, the optionally available scanner equipment is
required. In specific, the Soft Scan Plus (A, Fig. 6.2) is used instead of the usual laser focusing
handpiece. To this end, the articulated mirror arm must be connected to the scanner housing
(see thread 1, Fig. 6.2).
Fig. 6.2
Scanner for MCO25plus
A
B
C
1
2
3
4
5
Control signal transmission from the laser to the scanner requires connection of the scanner
cable.
* Requires optional scanner equipment
V 4.1
Scanner housing
Scanner handpiece, 127 mm
Scanner handpiece, 200 mm
Connection thread for articulated mirror arm
Socket for connecting the scanner to the laser
Irrigation gas connector
Beam exit with distance piece (tip)
Connection thread for scanning optics (red)
from
0.3 to 11 W
51
Advertisement
Table of Contents
