Table of Contents
Advertisement
MCO25plus Operating Instructions
Notice: Wipe only in one direction – not in a circle. If done correctly, this cleans
the optical surface without leaving any drying marks or streaks. Subsequently,
clean the other side in the same way. If the lens is very dirty, allow the solvent
some time to take effect before wiping it off. In cases where too much dirt has
accumulated or the lens is defective, the optics must be replaced.
Defective optics should not be discharged through the normal garbage collection!
Such components should be properly disposed of by Gebrüder Martin's Technical
Service or authorized service partner.
8.1.4
Cleaning the Backstops and Angled Tips
Fig. 8.3
A
B
C
D
E
The following tables show the processing options for the various accessories:
Cleaning options for accessories
Disinfecting solution
Steam sterilization, 134°C (273°F)
Gas sterilization
Plasma sterilization
Table 8.4
Processing options for backstops, adapters and angled working ends
V 4.1
Backstop for 127-mm focusing handpiece,
Backstop for 200-mm focusing handpiece,
Adapter for angled tip for 200-mm handpiece,
Angled tip, 90°,
Angled tip, 120°,
Backstop
127 mm
A
B
Backstop
,
,
200 mm
item no. 76-200-20
item no. 76-200-25
item no. 76-200-15
item no. 76-200-05-S
item no. 76-200-10-S
D
C
Angled
Adapter
tip, 120°
E
Angled
tip, 90°
77
Advertisement
Table of Contents
