Switching Off The Laser Unit - KLS Martin group MCO25plus Operating Instructions Manual

Co2 laser system
Table of Contents

Advertisement

MCO25plus Operating Instructions
5.8

Switching off the Laser Unit

Press the "standby" button.
Rotate the keylock switch counterclockwise by 90 degrees, then withdraw key and store it
in a safe place.
Notice: A laser unit currently not in use must be protected from unauthorized
operation by withdrawing the key.
Disconnect the footswitch and hang it on the hooks provided on the side of the unit (8, Fig.
3.1). The footswitch cable can be coiled around the hanging footswitch.
Clean all accessories, then store them away.
Using a suitable towel, clean or disinfect the outer surfaces of the unit in accordance with
hospital hygiene requirements. Take care, however, that no liquid penetrates into the
system in places where the unit has openings.
Never use sprays!
Set the articulated mirror arm to initial (non-use) position. This can be done in two ways:
1) The arm can be arrested in upright position, thus keeping it ready for operation (=
upper parking position).
2) Alternatively, it can be unlocked and folded down if the laser system needs to be
transported over greater distances (= lower parking position).
V 4.1
43

Advertisement

Table of Contents
loading

Table of Contents