Leaving/Joining Han; Commissioned Indicator - Landis+Gyr E470 Series User Manual

Service menu
19.2

Leaving/joining HAN

19.3

Commissioned indicator

D000058620 en a – E470 Series 3 SMETS2 100 mm – ZCX310 – User Manual and Functional Description
Issue 1.2
6. To switch off the IST mode again press button B briefly (<2 s).
7. Attach and seal the terminal cover again.
The leave HAN option will cause the meter to disconnect from the local
HAN (ZigBee network) and the join HAN option will cause the meter to
rescan for a communications hub.
Proceed as follows to leave or join the HAN.
1. Lift and replace the terminal cover in order to activate the terminal
cover tamper. This is required to get access to the service menu.
2. Press button A briefly (< 2 s) from the default display.
All segments of the LCD are lit (display check).
€
export
import
£
3. Press button A briefly (< 2 s). The In-service test (IST) display
appears.
I S T ?
4. Press button A briefly (< 2 s). The HAN display appears.
H A N ?
5. Press button B briefly (< 2 s). If the meter is currently joined, the Leave
HAN display appears.
L e a v e H A N ?
If the meter is currently un-joined, the Join HAN display appears.
J o i n H A N ?
6. Press button B briefly (< 2 s). The HAN is left or joined, respectively.
If the HAN is joined, attach and seal the terminal cover again.
If the meter has previously been commissioned then the commissioned
indicator symbol (c) appears on the Leave/Join HAN display indicating that
the meter may require refurbishment before being redeployed to a new
premise.
Cents/
Pence/
A = N o
B = Y e s
A = N o
B = Y e s
A = N o
B = Y e s ( c )
A = N o
B = Y e s ( c )
125/143
© Landis+Gyr