Fluid Level Checks; Check The Engine Coolant Level; Add Engine Coolant - SANY SY35U Operation And Maintenance Manual

Table of Contents

Advertisement

Machine Operation

FLUID LEVEL CHECKS

Complete the following procedures in this section before starting the engine.

Check the Engine Coolant Level

WARNING!
• Engine coolant is toxic. Avoid inhaling or ingesting engine coolant. If eyes or skin are
contaminated by coolant, wash the affected area with plenty of water and seek medical
treatment immediately.
• Engine coolant is under pressure when the engine is hot. Avoid contact with hot engine
coolant. Allow the engine to cool before removing the radiator cap.
Failure to follow these warnings could result in death or serious injury.
1. Prepare the machine for service. See "Maintenance
Safety" on page 2-8.
2. Open the engine hood and make sure the engine coolant
level in the overflow tank (1) is between the FULL and
LOW marks.

Add Engine Coolant

1. If the engine coolant level is low, remove filler cap (2).
2. Add engine coolant through the fill opening of the
overflow tank until the engine coolant is at the FULL
mark.
3. Install the filler cap after refilling.
NOTICE!
If the overflow tank is empty, there may be an engine coolant leak. Inspect for engine coolant
leaks. If a leak is not found, check the engine coolant level in the radiator. Contact a SANY
dealer for additional information.
4-6
Operation and Maintenance Manual — 0120
SY35U Excavator OMM
1
Fig. 4-1
2
0003773
SANY

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SY35U and is the answer not in the manual?

Table of Contents

Save PDF