Lockout/Tagout Procedure; Cleaning The Machine; Fluid Systems; Adding Fluids To The Machine - SANY SY35U Operation And Maintenance Manual

SY35U Excavator OMM

Lockout/Tagout Procedure

Always perform the lockout/tagout procedure before servicing the machine.

Cleaning the Machine

Always use hot water and mild, nonflammable, grease-cutting soaps or cleaning agents to clean the machine.
Never use flammable or caustic cleaning agents.
Never use high-pressure steam cleaners to clean the machine.
Always lubricate the machine thoroughly after cleaning to remove any water or soap residue.
Keep the mirrors and lights clean. Keep the cab and windows clean, if equipped.

Fluid Systems

Adding Fluids to the Machine

When adding fluids to the machine, be aware that fluid systems may be under pressure and hot.

Refueling

When adding fuel, shut down the machine before removing the fuel tank cap.
Fuel spills present a hazard if not cleaned up immediately.
Refuel only in a well-ventilated area. Never smoke or allow open flames nearby while refueling the machine.
Do not top-off the fuel tank.

High-Pressure Fluid Lines

WARNING!
• Never perform repairs to items while any system is under pressure.
• Never use your hands to check or feel for leaks. Always wear personal protective
equipment (PPE), and use a piece of wood or cardboard to check for leaks.
• If high-pressure fluids penetrate skin or get into eyes, seek medical attention immediately.
Failure to follow these warnings can result in death or serious injury.
Check for cracks in the lines or hoses and for swelling in the hoses.
NOTE: If there is any leakage from a line or hose, the surrounding area may be wet.
Replace lines and hoses immediately if leaks, swelling, or cracking are found or if failure occurs.
SANY Operation and Maintenance Manual — 0120
Safety
2-9