AutomationDirect DURAPULSE Series User Manual page 24

Chapter 1: Getting Started
Protective Functions
Operator Devices
Programming
Operator
Status Display
Interface
Key Functions
Enclosure Rating
Ambient Temperature -10°C to 40°C (14°F to 104°F)
Ambient Humidity
Environment
Vibration
Installation Location
Options
1–10 DURA
PULSE
General Specifications (cont.)
Electronic Thermal, Overload Relay, Auto Restart after Fault,
Momentary Power Loss, Reverse Operation Inhibit, Auto Voltage
Regulation, Over-Voltage Stall Prevention, Auto Adjustable
Accel/Decel, Over-Torque Detection Mode, Over-Torque Detection
Level, Over-Torque Detection Time, Over-Current Stall Prevention
during Acceleration, Over-Current Stall Prevention during Operation
9-key, 2 line x 16 character LCD display, 5 status LEDs
Parameter values for setup and review, fault codes
Output Frequency, Motor Speed, Scaled Frequency, Output Current,
Motor Load, Output Voltage, DC Bus Voltage, PID Setpoint, PID
Feedback, Frequency Setpoint
RUN, STOP/RESET, FWD/REV, PROGRAM, DISPLAY, <UP>,
<DOWN>, ENTER
Protected Chassis, IP20
20 to 90% RH (non-condensing)
9.8 m/s 2 (1G) less than 10 Hz, 5.9 m/s
Altitude 1000m or lower above sea level, keep from corrosive gas,
liquid and dust
Noise filter, input AC reactor, output AC reactor, cable for remote
operator, programming software, Dynamic braking resistor, input fuses
AC Drive User Manual
2 (0.6G) 10 to 60 Hz
1st Ed. Rev. D 05/2013