Wire The Main Circuit Terminal Block With Procedure B - YASKAWA CR700 Technical Manual

Note:
• Different drive models have different wiring cover shapes.
• Only clip the section of the wiring cover that applies to the wired terminal. If you clip areas that do not apply to wired
terminals, the protective enclosure will not keep its IP20 protective level.
• Tightly hold the cutaway section when removing pieces of the cutaway section. Pieces of the cutaway section can fly out
and cause injury.
• Make sure that the clipped section does not cause damage to the wires.
• If you use wires that are not specified by Yaskawa, the protective enclosure could lose its IP20 protective level, although the
wiring cover is correct. Contact Yaskawa or your nearest sales representative for more information.
5.
Put the wiring cover in its initial position. Put the cables through the holes cut from the wiring cover.
6.
Install the front cover and the keypad to their initial positions.

Wire the Main Circuit Terminal Block with Procedure B

◆
Notes on Wiring the Main Circuit Terminal Block
■
Note:
• After the wiring, do not twist or shake the electrical wires too much.
• Be sure to use only wires with the correct size, stripped wire length, and tightening torque as specified by Yaskawa.
• Use tools that fit the shape of the screw head to tighten and loosen the terminal block screws.
• Make sure that there are no loose stranded wires or frayed wires after wiring is complete.
Main Circuit Terminal Block Wiring Procedure
■
Remove the terminal cover before wiring the main circuit terminal block.
1.
Remove the screws on the terminal block cover and pull the terminal block cover away from the drive. Pull
the wiring cover away from the drive to remove the wiring cover after removing the terminal block cover.
A - Terminal block cover
YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual
2.13 Main Circuit Terminal Block Wiring Procedure
Figure 2.98 Reattach the Wiring Cover
B - Wiring cover
Figure 2.99 Remove the Wiring Cover
2
97