YASKAWA CR700 Technical Manual page 691

Note:
Refer to Setting Procedures for Multi-step Speed Operation on page 622
5: Multi-Step Speed Reference 3
■
Setting Value Function
5 Multi-Step Speed Reference
3
Note:
Refer to Setting Procedures for Multi-step Speed Operation on page 622
6: Jog Reference Selection
■
Setting Value Function
6 Jog Reference Selection
7: Accel/Decel Time Selection 1
■
Setting Value Function
7 Accel/Decel Time Selection
1
Note:
C1: Accel & Decel Time on page 600
Refer to
8: Baseblock Command (N.O.)
■
Setting Value Function
8 Baseblock Command (N.
O.)
The keypad flashes bb [Baseblock]. Acceleration always starts from the zero speed when the Run command is
input. The drive keeps the baseblock state when the Run command is not input.
WARNING! Sudden Movement Hazard. When you use a mechanical holding brake with the drive in a lifting application, you
must close the brake if an input terminal triggers the Baseblock command to stop drive output. If you enter the baseblock
command, the motor will suddenly coast and the load will slip, which can cause serious injury or death.
ON : Baseblock (drive output stop)
OFF : Normal operation
9: Baseblock Command (N.C.)
■
Setting Value Function
9 Baseblock Command (N.
C.)
The keypad flashes bb [Baseblock].
WARNING! Sudden Movement Hazard. When you use a mechanical holding brake with the drive in a lifting application, you
must close the brake if an input terminal triggers the Baseblock command to stop drive output. If you enter the baseblock
command, the motor will suddenly coast and the load will slip, which can cause serious injury or death.
YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual
V/f CL-V/f OLV CLV AOLV
Uses speed references d1-01 to d1-16 to set a multi-step speed reference.
V/f CL-V/f OLV CLV AOLV
Sets the drive to use the JOG Frequency Reference (JOG command) set in d1-17. The JOG Frequency command overrides
Frequency References 1 to 8 (d1-01 to d1-08].
V/f CL-V/f OLV CLV AOLV
Sets the drive to use Acceleration/Deceleration Time 1 [C1-01, C1-02] or Acceleration/Deceleration Time 2 [C1-03, C1-04].
for more information.
V/f CL-V/f OLV CLV AOLV
Sets the command that stops drive output and coasts the motor to stop when a baseblock command (N.O.) is input.
Figure 11.51 Baseblock Command Time Chart
V/f CL-V/f OLV CLV AOLV
Sets the command that stops drive output and coasts the motor to stop when baseblock command (N.C.) is input (turned OFF).
11.8 H: Terminal Functions
for more information.
Description
for more information.
Description
Description
Description
Description
11
691