When you touch the drive and circuit boards, make sure that you observe correct electrostatic
discharge (ESD) procedures.
If you do not follow procedures, it can cause ESD damage to the drive circuitry.
Do not do a withstand voltage test or use a megohmmeter or megger insulation tester on the
drive.
These tests can cause damage to the drive.
Use an inverter-duty motor or vector-duty motor with reinforced insulation and windings
applicable for use with an AC drive.
If the motor does not have the correct insulation, it can cause a short circuit or ground fault from insulation
deterioration.
Do not operate a drive or connected equipment that has damaged or missing parts.
You can cause damage to the drive and connected equipment.
Do not use steam or other disinfectants to fumigate wood for packaging the drive. Use
alternative methods, for example heat treatment, before you package the components.
Gas from wood packaging fumigated with halogen disinfectants, for example fluorine, chlorine, bromine, iodine
or DOP gas (phthalic acid ester), can cause damage to the drive.
Warning Label Content and Locations
◆
Warning labels can be found at the following locations on the product. The product must be used in accordance
with this information.
A - Warning label
YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual
NOTICE
Damage to Equipment
Figure i.1 Warning Label Content and Locations
i.2 Using the Product Safely
17