Verify Keypad Parameters And Drive Parameters - YASKAWA CR700 Technical Manual

6.
Push or
The keypad will show the "End" message when the write process is complete.
Note:
The keypad display differs depending on settings and conditions.
A - A1-02 [Control Method Selection] settings
B - o2-04 [Drive Model (KVA) Selection] settings (2
or 3 digits)
C - Parameter backup data is not registered

Verify Keypad Parameters and Drive Parameters

◆
This procedure verifies that the parameter setting values that were backed up in the keypad agree with the
parameter setting values in the drive.
Note:
• Always stop the drive before you start to verify the parameters.
• The drive does not accept Run commands while verifying parameters.
1.
Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not on
2.
Push (Menu).
3.
Push or
YASKAWA SIEPC71061723A YASKAWA AC Drive CR700 Technical Manual
to select the backed-up parameter data, then push
, push (Back) to show [Home] on
to select [Parameter Backup/Restore], then push
.
D - Backup data does not contain the date
Information
E - Backup date
.
.
3.4 Keypad Operation
163
3