Repeater Operation; I Accessing A Repeater - Icom IC-207H Instruction Manual

I Accessing a repeater

➀
Push [BAND] one or more times to select the desired band.
➁
Set the receive frequency (repeater output frequency).
(pgs. 15–19)
➂
Push and hold for 1 sec., one or more times, to se-
DUP
lect – duplex or + duplex.
• "DUP –" or "DUP" appears to indicate the transmit frequency for
minus shift or plus shift, respectively.
• When the auto repeater function is turned ON, (available for the
U.S.A. version only), steps ➁, ➂ are not necessary. (p. 31)
DUP T
H I 5
1
➃ Push [TONE] one or more times to turn ON the subaudible
tone encoder, according to repeater requirements.
• Refer to p. 26 for tone frequency settings.
• When the repeater requires a different tone system, see the page
at right.
DUP T
H I
5
1
➄
Push and hold [PTT] to transmit.
• The displayed frequency automatically changes to the transmit
frequency (repeater input frequency).
• The operating condition is automatically programmed into a
scratch pad memory. See p. 36 for details.
9
9

REPEATER OPERATION

• If "oFF" appears, confirm the offset frequency. (p. 27)
➅
Release [PTT] to receive.
➆ Push [MONI] to check whether the other station's transmit
signal can be directly received or not.
➇
To return to simplex, push
to clear the "DUP" indicator.
➈
To turn OFF the subaudible tone encoder, push [TONE]
one or more times until no tone indicators appear.
5
for 1 sec., once or twice,
DUP
24