I Programming Scan Edges - Icom IC-207H Instruction Manual

I Programming scan edges

Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into pairs of
scan edge channels, 1A/1b to 5A/5b, in memory channels.
➀
Push [BAND] to select a band, if necessary.
➁
Set the desired frequency in VFO mode:
➥ Push [V/MHz] to select VFO mode.
➥ Set the frequency using the tuning dial.
➥ Set other data (e.g. offset frequency, etc.) if required.
➂
Push [S.MW] momentarily.
• "!" and the memory channel number flashes.
[EXAMPLE]: Programming 145.30 MHz and 145.80 MHz for the VHF scan edges 1A and 1b.
then
Push
BAND
rotate
H I
H I
5
1
Push
MW
S.MW
momentarily
9 H I
5
1
continue pushing
MW
S.MW
9 H I
➃
Rotate the tuning dial to select a scan edge channel (1A to
5A).
➄
Push [ MW] for 1 sec. to program.
(S.MW)
• 3 beeps may sound and the frequency is programmed.
• Scan edge "x"b is automatically selected when continuing to push
[ MW] after programming.
(S.MW)
➅
To program a frequency for the other pair of scan edges,
1b to 5b, repeat steps ➂ to ➄.
• If the same frequency is programmed into both scan edges, pro-
grammed scan will not function.
Rotate
9 H I
5
1
M
5 9
1
Program 1b in the same manner.
9
SCAN OPERATION
Push
MW
S.MW
and hold
9
5
1
M
40