I Demonstration Display; I Squelch Delay - Icom IC-207H Instruction Manual

I Demonstration display

A demonstration function is available at power ON. This func-
tion gives you a quick visual introduction to the function dis-
play indicators.
➀
While pushing [BAND], push [PWR] to turn power ON.
• The transceiver cycles through a visual tour of the function dis-
play indicators.
➁
Push any switch to exit demonstration mode and enter the
normal operating condition temporarily.
NOTE: The transceiver automatically returns to demon-
stration mode after 2 min. in which no operations are per-
formed. To deactivate the demonstration display
permanently, turn power OFF, then while pushing [BAND],
turn power ON again.
OTHER FUNCTIONS

I Squelch delay

During operation, received signal strength often fluctuates.
This can result in annoying repeated opening and closing of
the squelch during reception of the same signal. The IC-207H
has a built-in squelch delay function which helps prevent this.
When both stations are operating from a fixed location, this
function should be set to "short" e.g. packet operation.
➀
Push [PWR] to turn power OFF.
➁
While pushing [SET], turn power ON to enter initial set
mode.
➂
Push [SET] one or more times until "Sqt" appears.
• Pushing [MONI] reverses the order of selection.
➃
Rotate the tuning dial to
set the squelch delay to
"L" (long) or "S" (short).
➄
Push [PWR] momentarily
to exit initial set mode.
14
INITIAL SET MODE
USING
The display shows the squelch
delay function is set to short.
62