Setting A Frequency; I Preparation - Icom IC-207H Instruction Manual

3

SETTING A FREQUENCY

I Preparation

D Turning power ON/OFF
Push [PWR] for 1 sec. to turn power ON or OFF.
D Operating band
The IC-207H can receive/transmit on the 144 MHz and
430(440) MHz bands, or receive only on the avionics band
d
(USA version only).
Push [BAND] one or more times to select the desired operat-
ing band.
• The frequency changes to indicate the selected band.
• The operating band cannot be changed unless you are in VFO
mode (see right).
Push [BAND] one or more times to select the de-
BAND
sired operating band.
15
Push [PWR] for 1 sec.
D VFO and memory modes
The transceiver has 2 normal operating modes: VFO mode
and memory mode.
Push [V/MHz] to select VFO mode when the transceiver is
not in VFO mode.
• If VFO mode is already selected, the digits below 100 kHz disap-
pear. In this case, push [V/MHz] again (or push twice depending on
version).
H I 9
5
1
VFO mode is selected.
Push [VFO] to select VFO mode.
VFO
H I 9
5
1
Appears when memory mode
is selected.