I Skip Channel Setting - Icom IC-207H Instruction Manual

I Skip channel setting

The memory skip function speeds up scanning by checking
only desired memory channels. Set the memory channels to
be skipped or scanned as follows.
9
H I 5
1
M
SKIP
➀
Push [BAND] to select the a band, if necessary.
➁
Select the memory channel to program or to cancel the
skip function on:
➥ Select memory mode by pushing [M/CALL] once or twice.
➥ Rotate the tuning dial to select the memory channel.
➂
Push [SET] one or more times until "CHS" appears as
shown above.
• Pushing [MONI] reverses the order of selection.
➃
Rotate the tuning dial to turn the skip function ON or OFF
on the selected channel.
• "~" appears : The memory channel is skipped during
(CHS-on) memory scan.
• "~" disappears : The memory channel is scanned during
(CHS-OFF) memory scan.
➄
Push [V/MHz] to exit set mode.
NOTE: Scan edge memory channels cannot be specified
as skip channels, however, they are skipped during mem-
ory scan anyway.
SET MODE
USING
The display shows that
memory channel 10 is set as
a skip channel.
Ä
Push [BAND] to select the desired band, if nec-
SET
essary.
B
Å
Select the memory channel to program or to
cancel the skip function on:
➥ Select memory mode by pushing [MR].
➥ Push [Y] or [Z] to select a memory channel.
Ç
Push [FSET] one or more times until "CHS" ap-
pears as shown at left.
• Pushing [GENT] reverses the order of selection
once entering set mode.
É
Push [Y] or [Z] to set or cancel the skip infor-
mation.
• See item ➃ at left for skip indicator details.
Ñ
Push [ECLR] to exit set mode.
9
SCAN OPERATION
42