I Microphone Address - Icom IC-207H Instruction Manual

I Microphone
address
The transceiver has 8 possible microphone addresses (in-
cluding OFF) to help prevent interference from other HM-90
. Set both the microphone address
WIRELESS MICROPHONES
and microphone dip switch to the same value as follows.
NOTE: When the supplied microphone is connected, the
transceiver rejects control signals from the HM-90 even
when the microphone address is matched.
D Microphone address
➀
Push [PWR] to turn power OFF.
➁
While pushing [SET], turn power ON to enter initial set
mode.
➂
Push [SET] a few times to
select the "Adr" display as
shown at right.
➃
Rotate the tuning dial to
set the microphone ad-
dress to 0–7 or to turn the microphone control OFF.
• When "Adr-oF" is selected, the transceiver rejects all control sig-
nals from the HM-90.
➄
Push [PWR] momentarily to exit initial set mode.
INITIAL SET MODE
USING
The display shows the mi-
crophone address is set to 2.
WIRELESS OPERATION
D Microphone dip switch
➀
Remove the switch cover from the microphone rear panel.
➁
Set the microphone dip switch and the microphone ad-
dress to the same value as shown below.
➂
Replace the switch cover.
MICROPHONE
ADDRESS
S1–1
Adr-0 OFF
Adr-1 (default) ON
Adr-2 OFF
Adr-3 ON
Adr-4 OFF
Adr-5 ON
Adr-6 OFF
Adr-7 ON
(S1)
Dip switch
ON 1 2 3
OFF
AFC
CALL
1
PGR
HIGH
4
13
DIP SWITCH
S1–2 S1–3
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF ON
OFF ON
ON ON
ON ON
Switch cover
LOCK
AFC-OFF PTT-M MW
MR VFO CLR
2 3 A
C-SQL DTMF D-OFF
MID LOW SET
5 6 B
58