I Using The Tuning Dial; I Using [Y]/[Z] Switches - Icom IC-207H Instruction Manual

3
SETTING A FREQUENCY

I Using the tuning dial

➀
Push [BAND] to select the desired band, if necessary.
➁
Rotate the tuning dial to set the frequency.
• If VFO mode is not selected, push the [V/MHz] to select VFO
mode.
• Frequency changes according to the selected tuning steps.
(p. 18)
➂
For the 1 MHz frequency setting, rotate the tuning dial after
pushing [V/MHz].
• Pushing [V/MHz] for 1 sec. starts a scan function. If this happens,
push [V/MHz] again to stop the scan.
H I
17
The display shows that the 1 MHz
9
5
1
tuning step is selected for the
VHF band.

I Using [Y]/[Z] switches

Push [Y] or [Z] to set the selected band's fre-
YZ
quency.
• If VFO mode is not selected, push [VFO] to select it.
• Frequency changes according to the selected tuning
steps. (p. 18)
• Pushing [Y] or [Z] for more than 0.5 sec. activates a
scan. If this happens, push [Y] or [Z] again to stop it.
NOTE: 1 MHz steps cannot be used via the [Y]/[Z]
switches.