I Packet Operation - Icom IC-207H Instruction Manual

14
OTHER FUNCTIONS

I Packet operation

D Data speed
For packet operation the transceiver can be set to one of two
data speeds: 1200 bps (default) or 9600 bps.
➀
Push [PWR] to turn power OFF.
➁
While pushing [SET], turn power ON to enter initial set
mode.
➂
Push [SET] one or more times until "bPS" appears.
• Pushing [MONI] reverses the order of selection.
➃
Rotate the tuning dial to
select the desired data
speed.
➄
Push [PWR] momentarily to exit initial set mode.
63
INITIAL SET MODE
USING
The display shows the data
speed set to 1200 bps.
The display shows the data
speed set to 9600 bps.
NOTE:
For 1200 bps operation—
• Disconnect the microphone plug from the microphone
connector during data transmission, otherwise the data
signal and voice signal are simultaneously transmitted.
For 9600 bps operation—
• When the transceiver is set for 9600 bps data transmis-
sion in INTIAL SET MODE, the microphone signal is au-
tomatically cut. Therefore, it is not necessary to
disconnect the microphone plug from the connector in
this case.
• When pushing [PTT] during data transmission, data
transmission is interrupted and voice signals have prior-
ity.