I Tuning step selection
Tuning steps are the minimum frequency change increments
when you rotate the tuning dial or push the [Y] or [Z]
switches on the microphone. The following tuning steps are
available:
• 5 kHz
• 10 kHz
• 12.5 kHz
• 20 kHz
• 25 kHz
• 30 kHz
NOTE: For convenience, select a tuning step that
matches the frequency intervals of repeaters in your area.
➀
Push [BAND] to select the desired band, if necessary.
➁
Push [V/MHz] to select VFO mode if another mode has
been selected.
➂
Push [SET] one or more times until "tS" appears as shown
below.
• Pushing [MONI] reverses the order of selection.
• Cancel the DTMF memory function in advance. (p. 48)
➃
Rotate the tuning dial to select the tuning step.
➄
Push [V/MHz] to exit set mode.
9
H I
5
1
15 kHz tuning step
SET MODE
USING
• 15 kHz
• 50 kHz
9
H I
5
1
25 kHz tuning step
SETTING A FREQUENCY
Ä
Push [BAND] to select the operating band, if
SET
necessary.
B
Å
Push [VFO] to select VFO mode.
Ç
Push [FSET] one or more times until "tS" ap-
pears as shown previously.
• Push [ENT] to reverse the order of selection.
• Cancel the DTMF memory function in advance.
(p. 48)
É
Push [Y] or [Z] to select the tuning step.
Ñ
Push [CLR] to exit set mode.
3
18