Memory Operation; I General Description; I Memory Channel Selection - Icom IC-207H Instruction Manual

6

MEMORY OPERATION

I General description

The transceiver has 150 regular memory channels, 10 scan
edge memory channels (5 pairs) plus 2 call channels (by de-
fault C1 is for VHF and C2 is for UHF, however both can be
set to VHF or both to UHF as desired); each of these can be
individually programmed with the following data.
• Operating frequency (pgs. 15–19)
• Duplex direction (DUP or DUP–) and its offset frequency
(pgs. 24, 25, 27)
• Subaudible tone encoder or tone squelch and its tone fre-
quency (pgs. 24–26)
• Skip information* (p. 42)
*Except for the scan edge memory channels.
29

I Memory channel selection

D Using the tuning dial
➀
Push [M/CALL] once or twice to display "!".
➁
Rotate the tuning dial to select the desired memory chan-
nel.
• Only programmed memory channels can be selected.
D Using [Y]/[Z] switches
Ä
Push [BAND] to select the desired band, if nec-
MR
essary.
Å
Push [MR] to select memory mode.
Ç
Push [Y] or [Z] several times to select the de-
YZ
sired memory channel.
• Pushing [Y]/[Z] more than 0.5 sec. activates a scan.
• If a scan is activated, push [Y] or [Z] again to stop it.
D Using the keypad
Ä
Push [BAND] to select the desired band, if nec-
MR
essary.
Å
Push [MR] to select memory mode.
Ç
Push [GENT] to activate the keypad for nu-
ENT
meral input.
C
É
Push 2 appropriate digit keys to input a chan-
nel number.
• When inputting non-programmed channel numbers
the previous memory channel appears.
• To select scan edge channels, "B" and "A" can be
used for A and b respectively.