Pocket Beep And Tone Squelch; I Pocket Beep Operation - Icom IC-207H Instruction Manual

I Pocket beep operation

This function uses subaudible tones for calling and can be
used as a "common pager" to inform you that someone has
called while you were away from the transceiver.
D Waiting for a call from a specific station
➀
Push [BAND] to select a band, if necessary.
➁
Set the operating frequency.
➂
Program the subaudible tone frequency in set mode.
• See p. 26 for programming details.
➃
Push [TONE] one or more times to indicate "T SQLS"
in the function display.
➄
When a signal with the correct tone is received, the trans-
ceiver emits beep tones and flashes "S".
• Beep tones sound for 30 sec. To stop the beeps manually, push
the tuning dial (or any key).
• "S" flashes continuously until step ➅ or ➆.
• When receiving another call while "S" is flashing, no beeps sound.
➅
Push [PTT] to answer.
• Tone squelch is automatically selected when transmitting.
➆
Push [TONE] once or twice to cancel the function.

POCKET BEEP AND TONE SQUELCH

Ä
Push [BAND] to select the desired band, if nec-
T SQLS
essary.
8
Å
Set the operating frequency.
Ç
Program the subaudible tone frequency in set
mode.
• See p. 26 for programming details.
É
Push [FUNC] then [➇T SQLS] to turn the
pocket beep ON.
Ñ
When a signal with the correct tone is received,
the transceiver emits beep tones for 30 sec.
and flashes "S."
Ö
Push [PTT] to answer or push [ECLR] to stop
the beeps and flashing.
• Tone squelch is automatically selected.
• Pushing [FUNC] then [➈TSQL] also selects the tone
squelch.
T-OFF
Ü
To cancel the function, push [FUNC] then
C
[GT-OFF].
D Calling a waiting station using pocket beep
A subaudible tone matched with the stations frequency is
necessary. Use the tone squelch on the next page or a sub-
audible tone encoder (pgs. 24, 25).
12
50