I Tone Scan - Icom IC-207H Instruction Manual

I Tone scan

By monitoring a signal that is being transmitted on a repeater
input frequency, you can determine the tone frequency nec-
essary to open a repeater.
➀
Push [BAND] to select a band, if necessary.
➁
Set the desired frequency to be checked for a tone fre-
quency e.g. repeater input frequency.
➂
Push for 1 sec. to start the tone scan.
T-SCAN
• To change the scanning direction, rotate the tuning dial.
➃
When the tone frequency is matched, the squelch opens
and the tone frequency is programmed into the selected
mode such as VFO, memory/call channel or scratch pad
memory.
• The tone scan pauses when a tone frequency is detected.
• The decoded tone frequency is used for the tone encoder or tone
encoder/decoder depending on the tone squelch ON/OFF set-
ting.
➄
Push [V/MHz] to stop the scan.
9
H I 5
1
POCKET BEEP AND TONE SQUELCH
Ä
Push [BAND] to select the desired band, if nec-
T SQL
essary.
9
Å
Set the desired frequency to be checked for a
tone frequency e.g. repeater input frequency.
Ç
Push [F-2] to start the tone scan.
É
When the tone frequency is matched, the
squelch opens and the tone frequency is pro-
grammed into the selected mode such as VFO,
memory/call channel or scratch pad memory.
Ñ
Push [ CLR] to stop the scan.
E
NOTE: The decoded tone frequency is programmed tem-
porarily when a memory or call channel is selected.
However, this will be cleared when overwriting the mem-
ory/call channel.
12
52