I Programming A Memory Channel - Icom IC-207H Instruction Manual

I Programming a memory channel

VFO mode settings, including the set mode contents such as
subaudible tone frequency, etc., can be programmed into a
memory channel.
➀
Set the desired frequency in VFO mode:
➥ Push [V/MHz] to select VFO mode.
➥ Set the frequency using the tuning dial.
➥ Set other data (e.g. tone frequency, etc.) if required.
➁
Push [S.MW] momentarily.
• "!" and the memory channel number flash.
➂
Rotate the tuning dial to select the memory channel to be
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 via the remote controller.
Push and
BAND
VFO
H I
Rotate
H I
1
M
Rotate for setting
freq., etc.
9 H I
5
1
Push
MW
for 1 sec. and continue pushing
S.MW
9
5 H I
MEMORY OPERATION
programmed.
• Memory channels not yet programmed are blank.
➃
Push [S.MW] for 1 sec. to program.
• 3 beeps may sound.
• Memory channel number automatically advances when continu-
ing to push [S.MW] after programming.
✔ CONVENIENT
Memory programming can be performed in versatile ways
e.g. memory channel to the same (or different) memory chan-
nel, memory channel to the call channel, etc.
Push
MW
S.MW
9 H I
5
1
9 H I
5
1
momentarily
9
5
1
M
9
5
1
6
30