I Transmitting A Dtmf Code - Icom IC-207H Instruction Manual

I Transmitting a DTMF code

D Using the DTMF memory function
(automatic transmission)
The selected DTMF code is transmitted at each push of the
PTT switch when the DTMF memory encoder is turned ON.
➀
Push for 1 sec. to turn the DTMF memory encoder
DTMF
ON.
• "d" appears in place of the 100 MHz digit.
➁
Push [SET] to enter the programming condition.
➂
Rotate the tuning dial to select the desired DTMF memory
channel.
➃
Push [PTT] to transmit the selected DTMF code.
• At each push of [PTT], the selected DTMF code is transmitted.
• The speaker emits the DTMF tones sent.
➄
Push for 1 sec. to cancel the function.
DTMF
• "d" disappears.
Ä
Push [FUNC] then [➅DTMF] to turn the DTMF
DTMF memory encoder ON.
6
• "d" appears in place of the 100 MHz digit.
Å
Push [FSET] to enter the programming condition.
Ç
Push [Y] or [Z] to select the desired channel.
É
Push [PTT] to transmit the selected DTMF
code.
• Each push of [PTT], transmits the DTMF code.
Ñ
Push [ECLR] to cancel the function.
DTMF MEMORY ENCODER
D Transmitting a DTMF memory channel directly
Ä
Push [FUNC] then [➅DTMF] to turn the DTMF
DTMF S memory encoder ON.
• "d" appears in place of the 100 MHz digit.
Å
Push [DTMF-S], then push the desired DTMF
channel number.
• "0" to "9" and "A" to "D" are available for channel
numbers.
Ç
Push [DTMF-S] again to deactivate the DTMF
setting.
É
Push [ECLR] to turn the DTMF memory en-
coder OFF.
• When the DTMF memory encoder is turned ON con-
tinuously, each push of the PTT transmits the previ-
ously selected DTMF code.
11
48