67 Deep Sleep Mode  22 - Otto Bock Genium X3 Instructions For Use Manual

Remote control
If the settings of another MyMode are to be modified, you must first switch to this MyMode (see Section 65 "My-
Mode Switching via remote control")
INFORMATION
The prosthetist's setting is usually found in the middle of the scale After adjustment, you can reset the
prosthetist's setting by moving the slider control into the middle
INFORMATION
The knee joint settings should be optimised by the prosthetist using X-Soft The remote control is not intended
for use by the prosthetist to configure the knee joint The patient can change the behaviour of the prosthesis to
a certain extent on a day-to-day basis using the remote control (eg while becoming accustomed to the pros-
thesis) The prosthetist can monitor the changes using X-Soft at the next appointment
The table below shows the adjustment parameters for the MyModes along with a brief description, the adjustment
range of the remote control around the value selected by the prosthetist and the absolute value range
Basic mode:
Slider name in X-Soft
Stance flexion resis-
tance
Swing flexion angle
Pitch
Volume
MyModes except friction brake mode:
Slider name in X-Soft
Gain
Pitch
Volume
Friction brake mode:
Slider name in X-Soft
Basic
Pitch
Volume
6.7 Deep Sleep Mode
INFORMATION
Advise your patients of the information in this section
The remote control can be used to place the knee joint in a deep sleep mode, in which power consumption is
minimised The knee joint offers no functionality in this mode
It can be awakened from deep sleep mode with the remote control or by connecting the charger
22 | Ottobock
Absolute range Remote control
adjustment range
120-180 ±10
55°-70° ±3°
1000 Hz - 4000 Hz 1000 Hz - 4000 Hz
0-4 0-4
Absolute range Remote control
adjustment range
0-100 ±10
1000 Hz - 4000 Hz 1000 Hz - 4000 Hz
0-4 0-4
Absolute range Remote control
adjustment range
0-180 ± 20
1000 Hz - 4000 Hz 1000 Hz - 4000 Hz
0-4 0-4
Description
Resistance against flexion motion eg
when walking down stairs or when sitting
on a chair
Maximum flexion angle in the swing
phase
Frequency (pitch) of the beeper for con-
firmation signals
Volume of the beeper for confirmation
signals
Description
Value for speed at which flexion re-
sistance increases as the knee angle
increases
Frequency (pitch) of the beeper for con-
firmation signals
Volume of the beeper for confirmation
signals
Description
Basic resistance for unloaded knee joint
Frequency (pitch) of the beeper for con-
firmation signals
Volume of the beeper for confirmation
signals
Genium X3 - Bionic Prosthetic System