Removing The Switch From A Din Rail Or A Rack - Cisco IE 3000 Series Hardware Installation Manual

Appendix B Installation In a Hazardous Environment
Figure B-26 Installing the Switch on a Rack
.
After the switch is mounted in the rack, connect the power and alarm wires, as described in the
"Connecting Power and Alarm Circuits" section on page
For instructions on how to remove the switch from a rack, see the
Rail or a Rack" section on page

Removing the Switch from a DIN Rail or a Rack

To remove the switch from a DIN rail or a rack, follow these steps:
Ensure that power is removed from the switch, and disconnect all cables and connectors from the front
Step 1
panel of the switch.
Use a tool such as a flathead screw driver to press in the space next to the tab on each of the latches and
Step 2
turn the screw driver clockwise. See
Push the DIN rail latches at the top of the switch up and the latches at the bottom of the switch down.
Step 3
Pull the switch out, and release the switch from the DIN rail. See
OL-13017-01
B-36.
B-35.
Figure B-19.
Cisco IE 3000 Switch Hardware Installation Guide
Installing the Switch
"Removing the Switch from a DIN
Figure B-27.
B-35