Cisco IE 3000 Series Hardware Installation Manual page 44

Chapter 2 Switch Installation
Verifying Switch Operation
Figure 2-14 Inserting Wires in the Power and Relay Connector
1
2
1 2
Power source positive connection Power source return connection
Use a ratcheting torque flathead screwdriver to torque the power and relay connector captive screws
Step 6
(above the installed wire leads) to 2 in-lb. See Figure 2-15.
Do not over-torque the power and relay connector captive screws. The torque should not exceed 2 in-lb.
Caution
Cisco IE 3000 Switch Hardware Installation Guide
2-18
OL-13017-01