Removing The Switch From A Din Rail - Cisco Catalyst IE 3 00 Series Installation Manual

Switch Installation
Figure 6: Position the Hooks Over the DIN Rail
3. Push the switch toward the DIN rail to cause the spring-loaded latch at the bottom rear of the switch to
move down, and snap into place.
After the switch is mounted on the DIN rail, connect the power and alarm wires, as described in
Alarm Circuits, on page
Note For instructions on how to remove the switch from a DIN rail, see
on page

Removing the Switch from a DIN Rail

To remove the switch from a DIN rail, follow these steps:
1. Ensure that power is removed from the switch, and disconnect all cables and connectors from the front
panel of the switch.
1
2
20.
19.
Removing the Switch from a DIN Rail
DIN Rail
Switch
Removing the Switch from a DIN Rail ,
Switch Installation
Connecting
19