Connecting The Power Converter To An Ac Power Source; Preparing The Ac Power Cord; Connecting The Ac Power Cord To The Power Converter - Cisco IE 3000 Series Hardware Installation Manual

Appendix B Installation In a Hazardous Environment
Figure B-41
1
1
2
Use a ratcheting torque flathead screwdriver to tighten the captive screw to 2 in-lb.
Step 3
Do not over-torque the power and relay connector captive screws. The torque should not exceed 2 in-lb.
Caution

Connecting the Power Converter to an AC Power Source

These sections describe the steps required to connect the power converter to an AC power source:
•
•

Preparing the AC Power Cord

To connect the power converter to an AC power source, you need a standard 18-gauge, unterminated AC
power cord. See
vary by country. See
Use copper conductors only, rated at a minimum temperature of 167°F (75°C).
Note
OL-13017-01
Connecting Wires to the Power Converter DC Output Terminal Block
3
2
1
2
3
1
2
4
DC power clip
Two-pin connector on the power convertor
Preparing the AC Power Cord, page B-53
Connecting the AC Power Cord to the Power Converter, page B-54
Figure B-42. Power cord connector types vary by country. Power-cord color codes also
Table 2-2.
5
6
7
8
3
Four-pin connector on the switch
Cisco IE 3000 Switch Hardware Installation Guide
Connecting the Switch to the Power Converter
B-53