Connecting The Protective Ground And Dc Power - Cisco IE 3000 Series Hardware Installation Manual

Verifying Switch Operation
Figure B-8
Step 4 Attach the appropriate adapter to the terminal, if needed.
Step 5 Connect the other end of the adapter cable to the PC or terminal adapter.
Step 6 Start the terminal-emulation software on the PC.

Connecting the Protective Ground and DC Power

These sections describe the steps required to connect a protective ground and DC power to the switch:
•
•
•
The Cisco IE 3000 switch can be used with an optional AC/DC power converter (PWR-IE3000-AC).
Note
For instructions on how to connect the power converter to the switch, see the
the Power Converter" section on page
Locate the power and relay connector in the switch accessory kit.
You can get replacement power and relay connectors (PWR-IE3000-CNCT=) by calling Cisco Technical
Note
Support. See the
page
Cisco IE 3000 Switch Hardware Installation Guide
B-16
Connecting to the Console Port
Grounding the Switch, page B-17
Wiring the DC Power Source, page B-19
Attach the Power and Relay Connector to the Switch, page B-24
"Obtaining Documentation, Obtaining Support, and Security Guidelines" section on
x.
Appendix B
B-49.
Installation In a Hazardous Environment
"Connecting the Switch to
OL-13017-01