Installing The Switch On The Wall - Cisco IE 3000 Series Hardware Installation Manual

Cisco systems switch installation guide
Hide thumbs Also See for IE 3000 Series:
Table of Contents

Advertisement

Chapter 2
Switch Installation
Figure 2-22
1
2
After the switch is mounted on the DIN rail, connect the power and alarm wires, as described in the
"Connecting Power and Alarm Circuits" section on page
For instructions on how to remove the switch from a DIN rail, see the
Note
Rail or a Rack" section on page

Installing the Switch on the Wall

To attach the switch to a wall or a panel, follow these steps.
Read the wall-mounting instructions carefully before beginning installation. Failure to use the
Warning
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system. Statement 378
OL-13017-01
Mounting the Switch on a DIN Rail in a Parallel Position
2
1
15-mm DIN rail
Foot in extended position
3
7.5-mm DIN rail
4
Foot in recessed position
2-32.
2-31.
Cisco IE 3000 Switch Hardware Installation Guide
Installing the Switch
4
3
"Removing the Switch from a DIN
2-27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents