Connecting Power And Alarm Circuits - Cisco IE 3000 Series Hardware Installation Manual

Connecting Power and Alarm Circuits

Figure B-27
Step 4 Remove the switch from the DIN rail.
Connecting Power and Alarm Circuits
After the switch is installed, you are ready to connect the DC power and alarm relays.
•
•
•
Cisco IE 3000 Switch Hardware Installation Guide
B-36
Removing the Switch from the DIN Rail
Information about the Sealed Relay Device, page B-37
Wiring the Protective Ground and DC Power, page B-37
Wiring the External Alarms, page B-38
Appendix B Installation In a Hazardous Environment
OL-13017-01