Verifying Switch Operation - Cisco IE 3000 Series Hardware Installation Manual

Chapter 2 Switch Installation
Follow these directions to remove or replace the compact flash memory card:
Locate the compact flash memory card slot on the bottom of the switch. See
Step 1
Figure 2-7
Step 2 Install or remove the card, as desired:
•
•

Verifying Switch Operation

Before installing the switch in its final location, power on the switch, and verify that the switch passes
the power-on self-test (POST).
These sections describe the steps required to connect a PC or terminal to the switch console port, to
power on the switch, and to observe POST results:
•
•
OL-13017-01
Removing the Compact Flash Memory Card from the Switch
1
To remove the card, grasp the card top, and pull it out. Place it in an antistatic bag to protect it from
static discharge.
To install a card, slide it into the slot, and press it firmly in place. The card is keyed so that you
cannot insert it the wrong way.
Connecting a PC or a Terminal to the Console Port, page 2-12
Verifying Switch Operation, page 2-11
Bottom
of switch
Cisco IE 3000 Switch Hardware Installation Guide
Verifying Switch Operation
Figure 2-7.
2-11