Removing The Switch From A Din Rail - Cisco Catalyst 2955 Installation Notes

Removing the Switch from a DIN Rail

Removing the Switch from a DIN Rail
To remove the switch from a DIN rail, follow these steps:
Step 1 Ensure that power is removed from the switch, and disconnect all cables and connectors from the front
panel of the switch.
Push down on the top of the DIN rail clip release tab with your finger. As the clip releases, lift the bottom
Step 2
of the switch, as shown in
Figure 5
1
2
Catalyst 2955 Switch DIN Rail Clip Installation Notes
6
Figure 5
Switch Removal in a Parallel Mounting Configuration
3
DIN rail clip DIN rail clip release tab
DIN rail
and Figure 6.
1
2
3
OL-5262-01