Removing The Switch From A Din Rail - Cisco Catalyst 2960-L Series Hardware Installation Manual

Switch Installation
Warning
To prevent airflow restriction, allow clearance around the ventilation openings to be at least: 3 in. (7.6 cm)
Statement 1076
Step 1 Position the switch directly in front of the DIN rail, making sure that the top of the DIN rail mount clip hooks over the
top of the DIN rail.
Figure 25: Mounting the Switch on a DIN Rail
Step 2
Rotate the switch down toward the DIN rail until the release tabs on the DIN rail mount clicks.
Step 3 Lift lightly on the bottom of the switch to ensure that it is firmly locked in place.

Removing the Switch from a DIN Rail

Step 1
Ensure that power is removed from the switch, and disconnect all cables and connectors from the front panel of the switch.
Cisco Catalyst 2960-L Series 8-Port and 16-Port Switch Hardware Installation Guide
Removing the Switch from a DIN Rail
31