Installing The Power Converter On A Din Rail, Wall, Or Rack Adapter; Connecting The Dc Power Clip - Cisco IE 3000 Series Hardware Installation Manual

Connecting the Switch to the Power Converter
Step 3 Put the two modules together so that the power module fits in the switch recess.
Push the upper module latches down and the lower module latches up to secure the power converter to
Step 4
the switch. See
Figure 2-40

Installing the Power Converter on a DIN Rail, Wall, or Rack Adapter

You install the power converter on a DIN rail, wall, or rack as you would a switch module. You should
first attach the power converter to the switch and then install the entire switch assembly on the DIN rail,
wall, or rack adapter. For more information, see the
section on page
Switch on the Wall" section on page
Warning This equipment is supplied as "open type" equipment. It must be mounted within an enclosure that is
suitably designed for those specific environmental conditions that will be present and appropriately
designed to prevent personal injury resulting from accessibility to live parts. The interior of the
enclosure must be accessible only by the use of a tool.
The enclosure must meet IP 54 or NEMA type 4 minimum enclosure rating standards. Statement 1063
To prevent the switch assemble from overheating, there must be a minimum of 3 inches (76.19 mm)
Caution
between any other device and the top, bottom, or sides of the switch assembly.

Connecting the DC Power Clip

The DC power clip is a prewired cable that connects DC power from the power converter to the switch
module. Because the power clip uses the Pwr A connector, you cannot use the alarm connections on that
connector.
Cisco IE 3000 Switch Hardware Installation Guide
2-46
Figure 2-40.
Pushing the Latches In
Pwr A (24V
DC or 48
VDC )
Rtn A
Majo r Alar
m
5
! WA RN ING
This unit
powe r cord. might have
more than
electr ic To reduc e the risk one
powe r cords shock disco
nnect the of
before servic two
ing unit.
1
Pwr B (24V
DC or 48
VDC )
6
Rtn B
Mino r Alar
m
2
Exp ress
Setu p
Sys tem
Pwr A
Alar m
Pwr B
7
Setu p
1 3
8
2
4
Cis co Ca
tal ys t
2-45, the "Installing the Switch on a DIN Rail" section on page
"Attaching the Power Converter to the Switch"
2-27, or the "Installing the Switch in a Rack" section on page
Chapter 2 Switch Installation
2-23, the "Installing the
2-29.
OL-13017-01