Connecting To 100Base-Fx Ports - Cisco IE 3000 Series Hardware Installation Manual

Chapter 2 Switch Installation
Figure 2-36
1
Connect the other end of the cable to the other device.
Step 2
By default, the switch detects whether an RJ-45 connector or SFP module is connected to a dual-purpose
port and configures the port accordingly. You can change this setting and configure the port to recognize
only an RJ-45 connector or only an SFP module by using the media type interface configuration
command. For more information, see the switch command reference.

Connecting to 100BASE-FX Ports

Follow these steps to connect a fiber-optic cable to an Cisco IEM-3000-8FM expansion module:
Class 1 laser product. Statement 1008
Warning
Do not remove the rubber plugs from the SFF module port or the rubber caps from the fiber-optic cable
Caution
until you are ready to connect the cable. The plugs and caps protect the SFF module ports and cables
from contamination and ambient light.
Before connecting to the SFF module port, be sure that you understand the port and cabling stipulations
in the
section on page C-4
Step 1 Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use.
Insert one end of the fiber-optic cable into the SFP module port. See
Step 2
OL-13017-01
Connecting to a Dual-Purpose Port
1
2
2
LC connector RJ-45 connector
"Preparing for Installation" section on page
for information about the LC connector on the SFF module.
Connecting Destination Ports
2-1. See the "Cable and Adapter Specifications"
Figure 2-37.
Cisco IE 3000 Switch Hardware Installation Guide
2-43