Appendix B
Installation In a Hazardous Environment
1
2
3
4
Connecting Modules
Follow these directions to connect the expansion modules to the switch:
Remove the side panel by firmly grasping both sides of it in the middle and pulling it outward. If
Step 1
necessary, use a screwdriver to pry open the side panel. See
Figure B-2
Remove the EMI protective cover from the connector on the switch. See
Step 2
Figure B-3
OL-13017-01
Cisco IE-3000-4TC switch with Cisco IEM-3000-8TM and Cisco IEM-3000-8FM
expansion modules (12 FE and 8 FX ports)
Cisco IE-3000-4TC switch with one Cisco IEM-3000-8FM expansion module
(4 FE and 8 FX ports)
Cisco IE-3000-4TC switch with one Cisco IEM-3000-8TM expansion modules
(12 FE ports)
Cisco IE-3000-4TC switch with two Cisco IEM-3000-8TM expansion modules
(20 FE ports)
Opening the Side Panel of the Cisco IE-3000-8TC Switch
Removing the EMI Cover
Adding Modules to the Switch
Figure
B-2.
Figure
Cisco IE 3000 Switch Hardware Installation Guide
B-3.
B-11