Connecting The Power Converter To An Ac Power Source; Preparing The Ac Power Cord - Cisco IE 3000 Series Hardware Installation Manual

Chapter 2 Switch Installation
Follow these steps to connect DC power from the power converter to the switch module.
Locate the DC power clip in the power converter accessory kit.
Step 1
Position the power clip so that the two-pin connector is over the power converter and the four-pin
Step 2
connector is over the switch Pwr A connector, and then slide the power clip into these two connectors.
See
Figure 2-41
1
1
2
Step 3 Use a ratcheting torque flathead screwdriver to tighten the captive screw to 2 in-lb.
Caution Do not over-torque the power and relay connector captive screws. The torque should not exceed 2 in-lb.

Connecting the Power Converter to an AC Power Source

These sections describe the steps required to connect the power converter to an AC power source:
•
•

Preparing the AC Power Cord

To connect the power converter to an AC power source, you need a standard 18-gauge unterminated AC
power cord. See
vary by country. See
Note Use copper conductors only, rated at a minimum temperature of 167°F (75°C).
OL-13017-01
Figure 2-41.
Connecting Wires to the Power Converter DC Output Terminal Block
3
2
1
2
1 3
2
4
DC power clip
Two-pin connector on the power convertor
Preparing the AC Power Cord, page 2-47
Connecting the AC Power Cord to the Power Converter, page 2-48
Figure 2-42. Power cord connector types vary by country. Power-cord color codes also
Table 2-2.
5
6
7
8
3 Four-pin connector on the switch
Cisco IE 3000 Switch Hardware Installation Guide
Connecting the Switch to the Power Converter
2-47