Removing The Switch From A Din Rail - Cisco IE-4000-4TC4G-E Hardware Installation Manual

Chapter 2 Switch Installation
Push the switch toward the DIN rail to cause the spring-loaded latch at the bottom rear of the switch to
Step 3
move down, and snap into place.
After the switch is mounted on the DIN rail, connect the power and alarm wires, as described in the
"Connecting Alarm Circuits" section on page
For configuration instructions about the CLI setup program, see the
Switch with the CLI-Based Setup Program."
For instructions on how to remove the switch from a DIN rail, see the
Note
Rail" section on page

Removing the Switch from a DIN Rail

To remove the switch from a DIN rail, follow these steps:
Ensure that power is removed from the switch, and disconnect all cables and connectors from the front
Step 1
panel of the switch.
Insert a tool such as a flathead screwdriver in the slot at the bottom of the spring-loaded latch and use it
Step 2
to release the latch from the DIN rail. See
Pull the bottom of the switch away from the DIN rail, and lift the hooks off the top of the DIN rail. See
Step 3
Figure
2-21.
2-10.
2-23.
Appendix A, "Configuring the
Figure 2-10.
Cisco IE 4000 Switch Hardware Installation Guide
Installing the Switch
"Removing the Switch from a DIN
2-21