Table of Contents
Advertisement
7. The front panel will display the word PROGRAMMER-19200. You should also see a menu appear in
the terminal window on the PC.
For example:
***** Unknown Main Flash Memory Chip *****
*****
Code Bank: 0 1 2 3 4 5 6 7
BLANK?
N N N N N N N N
Flash ROM is NOT valid
***** Intel Char Flash Memory Chip Detected *****
Code Bank: 0 1 2 3 4 5 6 7
BLANK?
N N N Y Y Y Y Y
Flash ROM is valid
-- MENU --------------------------------
<X>Modem download HEX file to Flash
<A>SCII download HEX file to Flash
<1> XModem download of font to Flash
<2> ASCII download of font to Flash
production <T>est (not implemented)
<Q>uit Programmer (Jump into Flash)
----------------------------------------
COMMAND:
8. The following is a list of possible reasons for failed communications:
•
Defective Serial cable.
•
Wrong communications port selected in the terminal program.
•
Improper port settings in the terminal program. (Refer to step 3 for settings).
•
Arrow key () not being pressed correctly during power-up.
9. Press '1' to initiate X-modem file transfer of the font information.
10. The boot code will prompt you to confirm that you want to erase the Flash ROM memory. Press 'Y'
to proceed, 'N' to cancel.
The Flash ROM must be erased first.
11. The boot code will indicate when the Flash memory is erased
Flash ROM is now BLANK. You may proceed.
12. Upload the character font "*.HEX" file supplied using the X-Modem transfer protocol of your terminal
program. If you do not start the upload within a short time the font loading operation will time out.
You can restart the process by selecting '1' from the menu again.
13. The boot code will indicate whether the operation was successful upon completion of the upload.
Download Complete!
TECHNICAL DESCRIPTION
Cannot Program
Model 8010TM SDI Time Code Master Manual
*****
Proceed (Y/N)
Revision 1.5.1
Page 5-7
Advertisement
Table of Contents
