Installing The Clutch Cover - Husqvarna FC 250 2018 Repair Manual

17 ENGINE
17.5.17
234

Installing the clutch cover

-e
D05933-10
Producing tool (special screw):
A conventional screw is required.
-
Cut screw f) to a length of
Guideline
I
Screw
I
Length G)
-
Cut a slot into the top end of the screw.
-
Mount screw f) and tighten hand-tight.
-
Mount clutch cover gasket
Info
Ensure that the dowel pins are seated properly.
-
Position the clutch cover.
Info
Ensure that the shaft seal rings of the water pump and
the crankshaft are not damaged.
-
Remove screw f).
8
-
Mount screws but do not tighten yet.
Guideline
I I
Screw, clutch cover
- (D
Mount screws but do not tighten yet.
Guideline
I I
Screw, clutch cover
- C,
Mount screw with the washer but do not tighten yet.
Guideline
I I
Screw, clutch cover
-
Tighten all the screws in a crisscross pattern.
Guideline
I I
Screw, clutch cover
@).
I
M6x70
I
60 mm (2.36 in)
O.
I
M6x25 1 0 Nm (7.4 lbf ft)
M6x45 1 1 0 Nm (7.4 lbf ft)
M6x25 1 1 0 Nm (7.4 lbf ft)
M6 1 1 0 Nm (7.4 lbf ft)