Installing The Clutch Cover - Husqvarna FE 350 2015 Repair Manual

ENGINE
18
18.5.17

Installing the clutch cover

-, -
�
I
•
1
e
-
Position spring retainer
-
Install the screws
Guideline
I
Screw, clutch spring
-
Using a straightedge and the special tool, check the spring washer for distortion.
I
Feeler gauge (59029041100)
I
Spring washer distortion
the specified value is not reached:
If
-
Remove screws
-
Using a straightedge and the special tool, check the spring washer for distortion.
I
Feeler gauge (59029041100)
I
Spring washer distortion
the specified value is not reached:
If
-
Remove screws
-
Using a straightedge and the special tool, check the spring washer for distortion.
I
Feeler gauge (59029041100)
I
Spring washer distortion
the specified value is not reached:
If
-
Change the clutch facing discs.
Create the tool (special screw):
A conventional screw is required.
-
Cut screw
Guideline
I
Screw
I
Length
Cut a slot into the top end of the screw.
304820-10
-
Put on the clutch cover gasket.
• Info
I
Ensure that the dowel pins are seated properly.
-
Mount screw
@)
with the I marking.
(D
and tighten them diagonally.
(i!!ll p. 291)
I
(D
and mount spring retainer with marking
(a p. 291)
I
(D
and mount spring retainer with marking
(i!!ll p. 291)
I
Q
to a length of f).
e
O
and tighten hand-tight.
I 6 Nm (4.4 lbf ft}
0 ... 0.10 mm (0 ... 0.0039 in)
II.
0 ... 0.10 mm (0 ... 0.0039 in)
Ill.
0 ... 0.10 mm (0 ... 0.0039 in)
I
M6x70
I
60 mm (2.36 in)
184