Table of Contents
Advertisement
0
I
C,.
-
Push on support ring
-
Sand the edges of the slide bearings with 600 grit sand-
paper; then clean and grease the bearings.
I Fork oil (SAE 4) (48601166S1)
-
Slide on lower slide bearing
-
Mount upper slide bearing (D .
Info
Without using a tool, pull the stack slightly apart
by hand.
-
Warm up the outside fork tube in area
slide bearings.
Guideline
so
c
I
(122 °F)
0
-
Hold the lower slide bearing with the longer side of the
special tool.
I Mounting tool (T14040S)
-
Slide on the outside fork tube.
-
Press the slide bearing all the way into the outside fork
tube.
-
Position the support ring.
-
Hold the seal ring with the shorter side of the special tool.
I Mounting tool (T14040S)
-
Press the seal ring and support ring all the way into the
outside fork tube.
-
Mount lock ring @ .
✓ The lock ring engages audibly.
O.
-
Mount dust boot
-
Mount fork protector ring G).
FORK, TRIPLE CLAMP 6
(8
p. 299)
0.
G
of the lower
(8
p. 318)
(8
p. 318)
37
Advertisement
Table of Contents
