Table of Contents
Advertisement
7.3
Ad"usting the basic �osition of the clutch lever
7 .4
Checking the rubber grips
-
First bolt the handlebar clamp with screws
longer, higher side of the handlebar supports so that both
parts touch.
-
Tighten screws
Guideline
Screw, handlebar
clamp
Finishing work
-
Mount the handlebar cushion.
-
Adjust the basic position of the clutch lever to your hand size
by turning adjusting screw
Info
When the adjusting screw is turned counterclockwise,
the clutch lever moves away from the handlebar.
When the adjusting screw is turned clockwise, the
clutch lever moves closer to the handlebar.
The range of adjustment is limited.
Only turn the adjusting screw by hand, and do not use
force.
Do not make any adjustments while riding.
-
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve
or the throttle tube.
401197-01
If a rubber grip is damaged or worn:
-
Change the rubber grip.
-
Check that screw
Guideline
Screw, fixed
grip
I The diamond
HANDLEBAR,CONTROLS 7
O
O
evenly.
M8
20 Nm (14.8 lbf ft)
O.
O
is firmly seated.
5 Nm (3. 7 lbf ft)
M4
G
must be located at the top.
onto the
Loctite
®
243
™
41
47
Advertisement
Table of Contents
