Table of Contents
Advertisement
20
LUBRICATION SYSTEM
262
I
�-@)
401955-12
(D
-
Pull oil filter
out of the oil filter housing.
I Lock ring plier (51012011000)
-
Completely drain the engine oil.
-
Thoroughly clean the parts and sealing surfaces.
-
Lay the motorcycle on its side and fill the oil filter housing to
about ½ full with engine oil.
-
Fill the oil filter with engine oil and position the oil filter in the
housing.
-
Oil the 0-ring of the oil filter cover and mount it together with
oil filter cover@.
-
Mount and tighten the screws.
Guideline
I
I
Screw, oil filter cover
-
Stand the motorcycle upright.
fD
-
Remove filler plug
from the clutch cover together with the
0-ring, and fill up with engine oil.
Engine oil
•
Info
I
Too little engine oil or poor-quality engine oil will result
in premature wear of the engine.
-
Mount and tighten the filler plug together with the 0-ring.
Danger
Danger of poisoning
inhaling them may result in unconsciousness and
death.
-
Always make sure there is sufficient ventilation
when running the engine.
-
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
-
Start the engine and check for tightness.
Finishing work
-
Check the engine oil level.
(8
p. 305)
M6
110 Nm (7.4 lbf ft)
1.0 I (1.1 qt.)
Engine oil
(SAE 1 0W/50)
(a
p. 29s)
Exhaust gases are toxic and
(8
p. 259)
Advertisement
Table of Contents
