Table of Contents
Advertisement
15.7
Checkin
15.8
Checkin the open-circuit current
WIRING HARNESS, BATTERY 15
-
Disconnect the battery charger after charging the 12 V bat
tery.
Guideline
The charging current, charging voltage, and charging time
must not be exceeded.
Recharge the 12 V battery
regularly when the motorcy-
cle is not being used
-
Finishing work
Connect the negative cable of the 12 V battery.
-
Mount the seat.
(8
p. 100)
-
Install the air filter box cover.
Condition
The 12 V battery must be fully functional and completely
charged.
-
Preparatory work
Remove the air filter box cover.
-
Remove the seat.
(0
p. 99)
-
Main work
Start the motorcycle to check the function.
Measure the voltage between the specified points.
V
Measuring point
Ground(-)
Charging voltage
I
5,000 rpm
If the displayed value is less than the specified value:
-
Check the plug-in connections from the alternator to
the voltage regulator.
-
Check the plug-in connections from the voltage regu-
lator to the wiring harness.
-
Check the stator winding of the alternator.
If the displayed value is greater than the specified value:
-
Change the voltage regulator.
-
Preparatory work
Press and hold the kill switch � while the engine is idling until
the engine stops.
-
Remove the air filter box cover.
-
Remove the seat.
(0
p. 99)
-
Disconnect the negative cable of the 12 V battery.
3 months
(0
p. 135)
(0
p. 95)
p. 95)
(0
(0
p. 13)
(+) - Measuring point
plus
13.5 ... 15.0 V
1
(0
p. 95)
(0
(0
...
p. 266)
...
p. 135)
139
Advertisement
Table of Contents
