Husqvarna FC 250 2018 Repair Manual page 130

14 WHEELS
128
-
Check the chain sliding guard for wear.
If the lower edge of the chain pins is in line with, or below,
the chain sliding guard:
-
Change the chain sliding guard.
-
Check that the chain sliding guard is firmly seated.
If the chain sliding guard is loose:
-
Tighten the screws on the chain sliding guard.
Guideline
Screw, chain
sliding guard
-
Check the chain sliding piece for wear.
If the lower edge of the chain pins is in line with or below
the chain sliding piece:
-
Change the chain sliding piece.
-
Check that the chain sliding piece is firmly seated.
If the chain sliding piece is loose:
-
Tighten the screw on the chain sliding piece.
Guideline
Screw, chain slid-
ing piece
-
Check the chain guide with a slide gauge for dimension (B .
Minimum thickness (B of
the chain guide
If the measured value is less than the specification:
-
Change the chain guide.
M6 6 Nm (4.4 lbf ft)
Loctite
M8 15 Nm
(11 .1 lbf ft)
6 mm (0.24 in)
®
243
™