Husqvarna FC 250 2018 Repair Manual page 105

FUEL TANK, SEAT, TRIM
Main work
-
Check throttle cable routing.
-
Position the fuel tank and fit the two spoilers laterally to the
radiator.
-
Make sure that no cables or throttle cables are trapped or
damaged.
-
Attach the fuel tank breather hose to the fuel tank lid.
-
Mount and tighten screw
Guideline
Remaining screws,
chassis
-
Mount and tighten screws f!}.
Guideline
Remaining screws,
chassis
fD
-
Plug in connector for the fuel pump.
-
Remove the wash cap set and thoroughly clean the plug-in
connection of the fuel line using compressed air.
Info
Under no circumstances should dirt enter into the fuel
line. Dirt in the fuel line clogs the injection valve!
-
Lubricate the O-ring and connect plug-in connection
the fuel line.
Info
Route the cable and fuel line at a safe distance from
the exhaust system.
Finishing work
-
Mount the seat. (0 p. 100)
-
Install the air filter box cover.
-
Install the right side cover.
(0 p. 48)
O
with the rubber bushing.
10 Nm (7.4 lbf ft)
M6
M6 10 Nm (7.4 lbf ft)
(0 p. 95)
(0 p. 99)
12
8
for
103